Check the error message displayed in the Control Panel and take action to resolve the error.

Check whether the machine’s IP address is set correctly.

Check the data-reception control setting.

The print data size transmitted at one time may have exceeded the upper limit of the receivable size of the machine. This can occur when the receiving buffer size setting is configured to [Spool to Memory]. Divide the print data into the size smaller than the maximum receivable size of the machine. If there are multiple pieces of print data, reduce the number of files to print at one time before printing.

The receiving buffer capacity may be insufficient. When printing high resolution documents, reduce the memory size of unused items in [Allocate Memory] on the Control Panel to increase the receiving buffer capacity.

Increasing the receiving buffer capacity may improve the print processing speed. Adjust the receiving buffer capacity according to the print data capacity. Also, disabling an unused port and assigning the memory for other uses is recommended.

The printing time may be shortened by changing the [Image Quality] setting on the [Image Options] tab of your printer driver to [Standard].

Printing may take time depending on the printing method of TrueType fonts. Set the printing method of TrueType fonts under [Specify Font] on the [Advanced] tab of your printer driver.

The printing speed might be lower depending on the paper type such as Heavyweight Paper or Coated Paper.

Also, if the machine internal temperature exceeds a certain level during continuous operation, the machine lowers the print speed. If operation is still continued or the internal temperature rises further, the machine stops operation due to the error. In that case, switch the machine power off, wait for a while until the machine’s internal temperature drops, and then switch the power on again.

If you have switched on the computer power after switching on the machine power, cancel printing.

Adjust the paper guides to the correct positions.

Check whether the paper margin setting is correct with your printer driver.

Adjust the print position in > [Device] > [Maintenance] > [Image Quality] > [Adjust Paper Registration].