Migrating from the Trial Version of FUJIFILM IWpro to the Full Version (Using the Control Panel)

This section describes the migration procedure for a tenant other than a tenant that is using the trial version of FUJIFILM IWpro.

When migrating to the full version during the trial period, the migration procedure is not required if you will continue to use the same tenant.
The devices registered for use with the trial version can continue to be used.

Prepare the following information for the setup process.

System administrator account and password of the new device to register to FUJIFILM IWpro
User ID and password of FUJIFILM IWpro administrator used with the trial version
User ID and password of FUJIFILM IWpro administrator that you entered a contract for.
- "FUJIFILM IWpro administrator" refers to FUJIFILM IWpro service users that are set as a tenant administrator (system administrator or operation administrator) or service administrator in FUJIFILM BI Direct.
- Administrator privileges for a "FUJIFILM IWpro administrator" will be assigned to the customer that enters a contract in advance

Step 1	Confirming the Network Settings of the Device (Using the Control Panel) Confirm the network settings of the device to use with FUJIFILM IWpro.

Step 2	Unregistering a Device (Using the Control Panel) Remove the apps from the device in the tenant using the trial version. Log in with the account ID for the trial version, then remove the apps installed to the device.

Step 3	Registering a New Device (Using the Control Panel) Log in with an account of the tenant that entered a contract. Install the apps to the device. The device is automatically registered to the tenant.

Step 4	Confirming That a Device Was Registered Successfully (Using the Control Panel) Confirm the operation of the functions installed to the device.