Adding Step Group

1.
Select the step name or step group name located in the upper area of the step group to be added, and click [Add Group].
This adds a new step group row in the lower area of the selected step name or step group name, and on the [Basic Settings] tab, [Step Group Name] and [Step Group ID] appear.
Note
  • Two empty lines are added at the same time, and the left column in the [Step] side is displayed with two lines integrated.
  • When you want to define two or more steps to the step group, select any of the step names belonging to the step group, and click [Add Step]. A new step setting line will be added to the step group.
2.
Enter [Step Group Name] and [Step Group ID].
Note
  • Enter [Step Group ID] using single-byte alphanumeric characters.
  • Up to 255 characters can be entered in each of [Step Group Name] and [Step Group ID].
3.
Click [Add Step].
In the [Basic Settings] tab, [Step Name] and [Step ID] are displayed.
4.
Enter [Step Name] and [Step ID].
Note
  • Enter [Step ID] using single-byte alphanumeric characters.
  • Up to 255 characters can be entered in each of [Step Name] and [Step ID].
5.
Click [Add Evidence Definition].
In the [Basic Settings] tab, the basic settings for document evidence definition are displayed.
6.
For the operations thereafter, refer to procedures 3 to 6 of "Editing Step Group (Step Group Definition)" as well as "Basic Settings of Document Evidence Definition".